Please see below a run-down of Focusrite product compatibility with Apple macOS Sierra as it currently stands. Please check that all other software/hardware you use to make music is also compatible before updating and never update your operating system during the middle of a time-critical project: Clarett 2Pre, 4Pre, 8Pre & 8Pre X Works with Sierra? YES - however there is a known issue with 5k Retina iMacs (model 17,1) when using macOS 10.12.3 and below, please see Red Range Works with Sierra? YES - however there is a known issue with 5k Retina iMacs (model 17,1) when using macOS 10.12.3 and below, please see Saffire firewire range (Pro 14, Pro 24, Pro 24 DSP, Pro 26, Pro 40, LS 56) Works with Sierra? YES Scarlett 2i2, Scarlett 2i4, Scarlett Solo ( 1st and 2nd Generation) Works with Sierra? Since I have upgraded to High Sierra my Scarlett 212 audio interface has. There is not a Focusrite driver for the Mac but the latest firmware is. The Scarlett Solo, 2i2 and 2i4 (1st and 2nd Generation) and the Saffire 6 USB (the USB. The larger Scarletts (6i6 and above) use software to control various. YES - however we are aware of an issue that can cause a kernel panic when using the 2nd Generation 'Low Latency Installer'. Please follow the steps at the bottom of to remove the kext file if your system crashes when connecting a 2nd Generation Scarlett. ** Sierra 10.12.2 update** We have encountered an issue where 2nd Generation Scarlett Solo/2i2/2i4 interfaces will appear as a separate Input and Output device in 'Audio MIDI Setup' on the latest build of Sierra (10.12.2). More information on how to address this can be found Scarlett 6i6, Scarlett 18i8, Scarlett 18i20 ( 1st and 2nd Generation) Works with Sierra? YES - however we are aware of an issue that can cause a kernel panic when using the 2nd Generation 'Low Latency Installer'. Please follow the steps at the bottom of to remove the kext file if your system crashes when connecting a 2nd Generation Scarlett. Points of note: If you experience any problems selecting your Scarlett as an input or output device on your Mac, please see. Scarlett 8i6, Scarlett 18i6 Works with Sierra? YES Saffire 6 USB 2.0 Works with Sierra? YES Points of note: If you are using the USB 2.0 version of the Saffire 6, no driver is required. Simply plug and play. If you are unsure whether your unit is the USB 1.1 or 2.0 version please check the serial number shown on the bottom of the device. If the serial number starts 'S2' it's a Saffire 6 USB 2.0, if it starts 'SU', it's a Saffire 6 USB 1.1. Saffire 6 USB 1.1 Works with Sierra? YES Please download the latest driver. Forte Works with Sierra? YES iTrack Solo Works with Sierra? YES VRM Box Works with Sierra? NO - VRM Box will appear as an output device and stream audio, however the VRM software will not work. RedNet Works with Sierra? YES Points of note: Requires RedNet Control 2. Red 2 & Red 3 plug-in suite Works with Sierra? YES Midnight plug-in suite Works with Sierra? YES Scarlett plug-in suite Works with Sierra? YES Points of note: If you have problems locating your license file please switch to Icon View. The folder may appear empty if you are in List View or Column View. If your product is not listed, it is not officially supported with macOS Sierra, you can find full details on our support policy. Couple of things. Is this a 2i2 - 2nd Gen? If so Focusrite released a low latency patch for it sometime ago, if you installed it, remove it, it generally causes more problems than not. Have to contact Focusrite support for that, if you haven't installed it don't. Things to look at. (even though it's system wide) Set Logic's Preferences Audio- Set Multithreading to 'Playback Tracks' Make sure the I/O buffer is set to 128 If you have installed 'Gobbler' uninstall it? Download and install the latest Focusrite driver. Thanks for the advice. Unfortunately, there's still a significant delay. I followed some instructions from the Focusrite support desk to re-set my audio device settings and checked the settings described in your post. This is a 214 (not 212) Second Gen and it's patched to the latest firmware. I set the Multithreading option to Playback tracks The I/O buffer was set to 128. (Setting it to 32 improved the performance in the Logic, but there's still a delay that was not noticeable before installation of High Sierra) I don't have Gobbler installed There is not a Focusrite driver for the Mac but the latest firmware is installed (V1116) I'd be grateful for any further thoughts. After around 1 year and a half using Scarlett 2i2 2nd gen I had this problem when I updated for High Sierra 10.13.1 and the post here helped me a lot. Thank you very much for posting the solution! The quality of Scarlett 2i2 2nd Gen is excelent. I think it is a isolated problem that they can solve it quickly. And indeed I contact the support.focusrite.com and they promptly sent me a solution.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2019
Categories |